ZW3D CAM can perform QuickMilling test run

\ZW3D CAM is so easy to use that you can perform a quick and dirty QuickMilling test run in just a few simple steps.

  1. Build a simple part.
     
  2. Open a CAM Plan.
     
  3. Click on Geometry > pick your part from the browser > YES.
     
  4. Click on OPERATIONS > Q-Mill (tab) > LACE (Finish pass).
     
  5. on Tool > Manage > OK > Close (this will use a default tool).
     
  6. Click on FEATURES.
     
  7. Click on your part above (This adds your part as a feature).
     
  8. on Lace 1 > Calculate.
       cad cam software


© 2013 ZWCAD Software Co., Ltd. All rights reserved.
All trademarks, trade names or company names referenced herein are used for identification only and are the property of their respective owners.