English
Google+
Information
Review date: 2011-Dec-29
Applies to:
,ZWCAD 2008,ZWCAD 2009,ZWCAD 2010,ZWCAD 2011,ZWCAD 2012,
- Forum
- Recent Posts
Hatch does not display.
Issue:
The hatch in the drawing does not display.
Solution:
If the hatch does not display, we can try to change two variables for trouble shooting. Set FILL=ON, and set MaxHatch=100000. The variable FILL is use to controls the filling of objects such as hatches, 2D solids, and wide polylines. If you create a very dense hatch, ZWCAD may reject the hatch and display a message indicating that the hatch scale is too small or its dash length too short. You can change the maximum number of hatch lines by setting the MaxHatch environment variable using (setenv “MaxHatch” “n”) where n is a number between 100 and 10000000 (ten million).
PDF
© 2013 ZWCAD Software Co., Ltd. All rights reserved. | About ZWSOFT
| Privacy Policy | Terms and Conditions |
Contact us | Site Map
All trademarks, trade names or company names referenced herein are used for identification only and are the property of their respective owners.
CAD | CAD Software | CAD Free Download | CAD Download | Design Software | Free Cad Download | 3D Software Download
All trademarks, trade names or company names referenced herein are used for identification only and are the property of their respective owners.
CAD | CAD Software | CAD Free Download | CAD Download | Design Software | Free Cad Download | 3D Software Download