Hatch does not display.

December 29, 2011

Issue:

The hatch in the drawing does not display.

 

Solution:

If the hatch does not display, we can try to change two variables for trouble shooting. Set FILL=ON, and set MaxHatch=100000. The variable FILL is use to controls the filling of objects such as hatches, 2D solids, and wide polylines. If you create a very dense hatch, ZWCAD may reject the hatch and display a message indicating that the hatch scale is too small or its dash length too short. You can change the maximum number of hatch lines by setting the MaxHatch environment variable using (setenv “MaxHatch” “n”) where n is a number between 100 and 10000000 (ten million).

Information

Review date: 2011-Dec-29
Applies to:
,ZWCAD 2008,ZWCAD 2009,ZWCAD 2010,ZWCAD 2011,ZWCAD 2012,

PrintPrint Get a PDF version of this webpage PDF
2013 ZWCAD Software Co., Ltd. Todos los Derechos Reservados. | Política de Privacidad | Términos y Condiciones | Mapa del Sitio