How to go back to a special step after overusing UNDO in ZWCAD?

December 29, 2011

Issue:

UNDO is useful to cancel the mistake and go back to the right state, we can use Ctrl+Z or command UNDO to make it work. But sometimes you might overuse it and want to go back to a special step, how?

 

Solution:

Input command MREDO and then input the step that you want to restore. This command is used to reverse the effects of several previous UNDO or U commands. Besides, you can also use Ctrl+Y to go back step by step.

 

Information

Review date: 2011-Dec-29
Applies to:
,ZWCAD 2008,ZWCAD 2009,ZWCAD 2010,ZWCAD 2011,ZWCAD 2012,

PrintPrint Get a PDF version of this webpage PDF
2013 ZWCAD Software Co., Ltd. Todos los Derechos Reservados. | Política de Privacidad | Términos y Condiciones | Mapa del Sitio