BIND

zw_admin — 2008-06-23 13:56:43

Hello Jair Ribeiro, Xbind is a new function for zwcad. Our R&D colleague has added it to the list, and the problem No. is 5725, please give us some to do it. If there is any new information about the issue, I will publish it in the forum. Thank you very much for your suggestion. Have a pleasant day.

zw_admin — 2008-06-18 09:36:27

bind????????

maker — 2008-05-05 23:39:37

Hello Rab, Actually, when I tried it again, after some time, I didn't get the problem. But it did take a very long time to bind - I thought it had crashed. Also typing XBind on command line gives 'this command is not yet supported'! Whey? -when it is supported when going through the xref dialogue box. I'll recheck for the problem, and send you the test file I used, if confirmed. Thanks, -maker-

zw_admin — 2008-05-05 21:41:56

Hello, Maker. I have taken a try according to your description and the position of the inserted object is the same as origin. So when you are free, please test it again and give us more info. As for the Xbind command, I have submitted it to our R&D dept.

maker — 2008-05-05 00:38:08

Hello Rab, Maybe this: XRef-->Bind-->insert seems to move lthe position of the inserted object. I've not tested very much; I'll do so later when I get time. Also Xbind command (commandline) gives: "This command is not yet supported" Hope this helps.

zw_admin — 2008-05-04 22:18:39

Hello, Jair. Could you describe your problem in detail? I took a try in ZWCAD2008i version. And it perfoms well. So please provide more info so that we can check out the problem.

zw_admin — 2008-04-30 12:43:55

xref.manger bind

zw_admin — 2008-04-29 16:53:12

ZWCAD2008i BIND????