http://www.zwsoft.com/forum/viewthread.php?tid=1440 <font size="2"><font face="Arial, Helvetica, sans-serif">Having been employed most of my life, I have now decided to run my own business from home and find that drawing work is in great demand. Have been using various versions of Acad since 1994. I received a copy (CD) of the trail copy from the local ZWCAD distributor yesterday. Having installed the programme decided to test it. The following problems were experienced: 1) Dimension text size could not be changed either in format mode or by modify properties. 2) My drawing comprised of two circles forming a ring which needed to be divided into 26 segments. When I attempted to polar array the line joining the circles which I did according to normal practice, I found that the selected 360 degree array ended up as 270 degrees. I changed the angle to fill from by adding 90 degrees 90 degrees i.e. 360 + 90 = 450 degrees managed to achieve my result??? 3) I also discovered that the zoom-in function was limited and unable to zoom past a certain limit. 4) The format dimension activity is also confusing in that it refuses to be edited without indication some obscure message. QUESTION: Are these problems current or is the CD copy a beta version? The problems were experienced within 30 minutes of using ZWCAD. So I not aware of any other glitches. Although I am extremely interested in acquiring a copy of ZWCAD I would be hesitant in do so at the moment.. I would be grateful if someone could could assist me? My only alternative is to resort purchasing very costly AutoCad which I am very reluctant to do. Wilbri </font></font> Wilbri 2009-11-25 04:31:34