http://www.zwsoft.com/forum/viewthread.php?tid=1667 G'day Guys/Girls I am getting into the 3D thing of zw (never done 3D before) So I need a little advice. I would like to know how I can remove sections of a solid to make holes and hollow sections in it? I can draw it, extrude it and render it but, any holes in the shape are not recognised as such and are automatically rendered also. Same applies to a hollow beam section. How do I remove (or leave out ) the end caps the rendering puts in? I tried Shell command but either it doesn't work or I'm doing it wrong. And finally: Is there a ZWCAD 3D tutorial somewhere I can access? TIA, for your help.<img src="smileys/smiley1.gif" border="0" align="absmiddle" alt="Smile" /> zw_admin 2010-10-24 23:58:15 http://www.zwsoft.com/forum/viewthread.php?tid=1667&pid=13881 <a href="uploads/20111007_205128_Getting_Started.pdf" target="_blank">20111007_205128_Getting_Started.pdf</a> I am getting into the 3D thing of zw (never done 3D before) So I need a little advice. I would like to know how I can remove sections of a solid to make holes and hollow sections in it? I can draw it, extrude it and render it but, any holes in the shape are not recognised as such and are automatically rendered also. Same applies to a hollow beam section. How do I remove (or leave out ) the end caps the rendering puts in? I tried Shell command but either it doesn't work or I'm doing it wrong. And finally: Is there a ZWCAD 3D tutorial somewhere I can access? For You. I think it will help you. Goodluck! <a href="http://www.beaconfoundations.com/our-partners" target="_blank">Educational Assistance</a> <a href="http://www.koowii.com/web-hosting/ecommerce-solutions/magento-hosting/" target="_blank">Australian Magento Hosting</a> mizzfail 2011-10-07 20:52:33