http://www.zwsoft.com/forum/viewthread.php?tid=2328 I noticed that when i move or rotate some 2d drawing that has a Solid Hatch on it, after placing to a new position or angle, the drawing looks disturbed. I saw that this was because the hatch "swam up" on the front the drawing, so the lines could not be seen because of it. Until now, i have been solving this by entering the Hatch Edit, then chose from Draw order: Send to back. And then the thing are ok But i have to repeat this process on some hatches (on some not) every time i move or rotate the drawing (that consists hatch). Is there any way i could avoid this "Send to back" process every time? Is there a way to keep the hatch "to back" once and forever i set it at this option? TroutKing 2012-07-20 14:03:36 http://www.zwsoft.com/forum/viewthread.php?tid=2328&pid=15530 You could create a macro or button to set HPDRAWORDER to 1. This is the system variable that gets set when you go into the [url=http://www.zwsoft.com/Service_Support/ser_zwcad/Tips_and_Tricks/Hatch_Efficiently_in_ZWCAD.html]hatch[/url] edit and will send all hatches to the back. May still be a repeated process, but it bypasses the [url=http://www.zwsoft.com/Service_Support/ser_zwcad/Tips_and_Tricks/Hatch_Efficiently_in_ZWCAD.html]Hatch[/url] dialog box. skyface 2012-07-20 14:54:37