http://www.zwsoft.com/forum/viewthread.php?tid=2335 [p=30, 2, left]Hi[/p] [p=30, 2, left]Pse excuse crossposting but getting no response in Beginners, and I'm stuck ......[/p] [p=30, 2, left]Just setting out in zwcad 2011 3d. Can't get any of the solidedit tools to do anything to a simple box solid, other than change face colour. What am I missing?[/p] Profcad 2012-07-23 17:52:20 http://www.zwsoft.com/forum/viewthread.php?tid=2335&pid=15549 Your Drawing1.dwg example has no deletable faces. ZWcad solids are fully enclosed volumes and, if you were to delete a face, it would not be fully enclosed. If you want to elimnate the arc on the top use Solidedit-Body-cLean. If you want an open "shoebox" type solid then SolidEdit-Body-Shell and when propted to remove face select the face that would be open.* Enter a wall thickness. This will create an enclosed volume by evacuating the middle up to the wall thickness. * If an edge is selected it will include every face that shares that edge. You may have to re-add a face if it is to remain a closed portion. Ravi_Akella 2012-07-23 17:54:18