http://www.zwsoft.com/forum/viewthread.php?tid=2417 [size=4]I was doing this isometric drawing for my pipe spools and suddenly says function error[/size][size=4]and I wasn't able to use the command again, unless I close ZWCad.[/size] [size=4] [/size] [size=4]Then, if I am going to close the ZWCad, a pop up will show the runtime error[font=Arial, Helvetica, sans-serif][color=#222222].[/color][/font] [/size] [font=Arial, Helvetica, sans-serif][size=4][color=#222222] [/color][/size][/font] [font=Arial, Helvetica, sans-serif][size=4][color=#222222]I have attached two screenshots I am getting everytime I am doing a isometric drawings.[/color][/size][/font] [size=4] [/size] joseen4859 2012-09-06 03:51:55 http://www.zwsoft.com/forum/viewthread.php?tid=2417&pid=15911 Hello sir, thanks for the feedback. ZWMech is developed by ASVIC from Australia, please contact them directly for support request: [url]http://www.asvic.com.au/support.asp[/url] huangy8949 2012-09-06 10:12:23 http://www.zwsoft.com/forum/viewthread.php?tid=2417&pid=15910 [attach]554[/attach] [attach]553[/attach] joseen4859 2012-09-06 03:58:58