http://www.zwsoft.com/forum/viewthread.php?tid=586 Has anyone seen an issue with 12.66 not reading an stl stock for verification? When I try it I get a simple box instead of my desired stl model. I know this worked in the past. gjohn 2007-01-03 10:29:23 http://www.zwsoft.com/forum/viewthread.php?tid=586&pid=2762 Certainly the STL file output from VX Solid Verification would normally be a good file. The world isn't perfect though, there are always going to be exceptions. ChrisW 2007-01-04 08:10:19 http://www.zwsoft.com/forum/viewthread.php?tid=586&pid=2761 I have not but the stl is from a VX part that was made in VX. I would think that would be good wouldn't it? gjohn 2007-01-04 04:59:38 http://www.zwsoft.com/forum/viewthread.php?tid=586&pid=2758 Hi George It is probably STL file specific - have you tried an existing VX file that successfully used an STL for Solid Verify in a previous VX version? ChrisW 2007-01-03 14:42:25