http://www.zwsoft.com/forum/viewthread.php?tid=843 Clock core and cavity with VX mold & Die function, but partline plane has a little problem. zw_admin 2010-02-10 09:02:44 http://www.zwsoft.com/forum/viewthread.php?tid=843&pid=4563 Steve, Take a look at the attached image. The highlighted surface was created from the "red" parting line and was coincident with the dark blue face. Therefore, it could not sew properly. Because this face does not have any draft the parting line was created incorrectly. You can trim the face then sew, like I did or go back and replace the parting line then create the parting surfaces again. The draft analysis tools should find this. LynchMikeVX 2010-02-10 13:28:08 http://www.zwsoft.com/forum/viewthread.php?tid=843&pid=4562 Yes, it is no problem now, but when design partling plane has problem, you can replay history record find it. zw_admin 2010-02-10 12:08:01 http://www.zwsoft.com/forum/viewthread.php?tid=843&pid=4561 I can't see the problem (I can open the VX file) , can you upload a .png screenshot that shows what the problem is? ChrisW 2010-02-10 11:38:20 http://www.zwsoft.com/forum/viewthread.php?tid=843&pid=4560 I have no problems opening 7zip files, clicking on your attachment sends me to a "page not found" error. SteveMackay 2010-02-10 11:21:19 http://www.zwsoft.com/forum/viewthread.php?tid=843&pid=4559 I understand your meaning, I compressed a file of .zip format zw_admin 2010-02-10 11:12:09 http://www.zwsoft.com/forum/viewthread.php?tid=843&pid=4558 Your attachment doesn't work. SteveMackay 2010-02-10 10:59:04