get templatedrawing
get templatedrawing
14-02-2008 02:38 . pm | View his/her posts only
Why doesn't ZWCAD in case of a new drawing uses the template folder set in config, but looks instead in the actual folder.
Or do I make a mistake ?
stonie
Or do I make a mistake ?
stonie
get templatedrawing
12-02-2008 09:41 . pm | View his/her posts only
Hi,stonie.
It sounds normal in my computer, when i change the default path in config, then i new a draw, it displays the new path:
It sounds normal in my computer, when i change the default path in config, then i new a draw, it displays the new path:
get templatedrawing
14-02-2008 02:38 . pm | View his/her posts only
I tried it again, but is does not work.
get templatedrawing
10-03-2008 02:06 . am | View his/her posts only
Thank you for your question.
You can change the path of "Templetes Search Path" to get what you want. But you can't add a new one.
1. Run command OP;
2.On the page of Files, select the path under "Templetes Search Path" and specify the right path.
You can change the path of "Templetes Search Path" to get what you want. But you can't add a new one.
1. Run command OP;
2.On the page of Files, select the path under "Templetes Search Path" and specify the right path.
