CAD software discussion forum > CAD > Can't trim hatch in ZWCAD

Can't trim hatch in ZWCAD

Rank: 5Rank: 5

Juliana Oliveira de

ZWCAD Reseller

posts: 0

Registered: 2008-4-4

Message 1 of 2

 Can't trim hatch in ZWCAD
01-01-1970 08:00 . am | View his/her posts only
Why can't I do the trim in hatch?

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 2 of 2

19-03-2008 02:02 . am | View his/her posts only
Hello Julimorais,
"Island Detection Options" may affect trim. When "Outer Only" or "Ignore Island" is chosen, corresponding hatch can not be trimmed. To trim the hatch, "Nested Islands" should be chosen.
See also