CAD software discussion forum > Other CAD/CAM Technology > How to set Dynamic prompt off

How to set Dynamic prompt off

Rank: 1



posts: 0

Registered: 2012-1-14

Message 1 of 1

 How to set Dynamic prompt off
11-06-2009 09:24 . am | View his/her posts only
Dynamic Prompt indicates the relevant function you might be used near the cursor, it is quite useful. In case that you don't like it, you can use the following way to set it OFF.

Command: dynmode Enter
Command:0 Enter

And it is off now, if you want to set it ON, it is also simple, just set dynmode=1
See also