CAD software discussion forum > CAD > ZWCAD 2010 still does not support STB plot style

ZWCAD 2010 still does not support STB plot style

Rank: 1

bobob

Newbie

posts: 0

Registered: 2010-1-16

Message 1 of 2

 ZWCAD 2010 still does not support STB plot style
16-01-2010 03:42 . am | View his/her posts only
Hello,

I just downloaded the trial of 2010. I am disappointed that it AGAIN does not support STB plotting.



To mention, the speed is really improved.

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 2 of 2

19-01-2010 06:04 . pm | View his/her posts only


Dear BObob,


Thank you very much for your information. We didn't forget we said that the STB plotting function was probably supported in the ZWCAD 2010 version. In fact, we had put it in our development plan of this new version. But we had to postpone this function because of the tight schedule. We sincerely appologize for the delay. We will send your requirement to our R&D department again and if there is any progress about it, we will inform you soon.

Besides, there are many other improvements in 2010 version except for the speed. Hope these modification can bring to you more convenience.

Best Regards,

Denny
See also