OPEN FILE PROBLEM

Rank: 1

xiaoxin

Newbie

posts: 0

Registered: 2010-12-6

Message 1 of 5

06-12-2010 08:16 . pm | View his/her posts only
DEAR ALL,

WHEN I OPEN A NEW DWG FILE, THERE HAS A WINDOWS POP UP WITH ERROR MESSAGE "There was a problem sending the command to the program". DO ALL OF YOU HAVE ANY IDEA ABOUT THIS PROBLEM?

THANKS.

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 2 of 5

 OPEN FILE PROBLEM
07-12-2010 12:55 . am | View his/her posts only
Dear xiaoxin,

Are you using Windows 7 system? If so, there is a existing problem of ZWCAD on Win 7, when open some drawings, it will appear this error . The problem ID is 12195, you can keep it for further inquery.

But as I know it doesn't have any effect on the drawing , close this message, you can still normally open the drawing , edit and save.

Thanks for the feedback

Rank: 1

davide

Newbie

posts: 0

Registered: 2011-5-31

Message 3 of 5

31-05-2011 07:53 . am | View his/her posts only
The same problem I've encountered with dwg file in local hard drive with win7. I'f I try to openfile in a nas server zwcad will prompt ah another error and will not open the project.

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 4 of 5

 OPEN FILE PROBLEM
07-12-2010 12:55 . am | View his/her posts only
[QUOTE=davatz]The same problem I've encountered with dwg file in local hard drive with win7. I'f I try to openfile in a nas server zwcad will prompt ah another error and will not open the project.

May I know what is the another error message? can you show me a screenshot? thanks!

Rank: 1

jemesright

Newbie

posts: 0

Registered: 2012-1-6

Message 5 of 5

 OPEN FILE PROBLEM
07-12-2010 12:55 . am | View his/her posts only
Hi. I found this post after searching for a solution to the "could not
open install.log" problem. I downloaded a free registry cleaner (which i
have now been told is never a good idea) but when i go to uninstall it i
see the same message. The only problem is when i go to the location
where the program is installed, there is no "install.log" file anywhere.
Could it have been a problem caused by using the registry cleaner
itself?! Please help because i want rid of it!
Clap
See also