Zooming problem
Zooming problem
26-05-2011 03:34 . pm | View his/her posts only
|
Hello, i dont know if this has been answered before, but i couldnt find anything. I have the following problem. In autocad, when u roll with the middle button of the mouse, it zooms in and out. In zwcad though, when i do the same thing (rolling with the middle button of the mouse, up or down) a message appears that says that its already zoomed all. I cant remember the exact message, hope you understood. Do u know how i can change/fix this? thanks. |
Zooming problem
01-06-2011 01:18 . am | View his/her posts only
Hi,
I think I have seen such kind of messages, because it really reaches the extent of zoom in/out.
If you are viewing a large drawing, when it can not be fully zoomed in or out, try to double click the middle button for "zoom extent", then you can use the rolling button to zoom again.
Zooming problem
01-06-2011 01:18 . am | View his/her posts only
I think that, if you make a REGEN when that message appears, it will extent the percentage of ZOOm for a little high. This problem occurs on 2010, I think, right?
