ZWSOFT User Community > ZWSOFT Forums - Find. Share. Connect. > ZWCAD > SetControlPoint method in Pro 2012 beta
SetControlPoint method in Pro 2012 beta
SetControlPoint method in Pro 2012 beta
31-10-2011 04:21 . am | View his/her posts only
Hi all !
Another old bug.
SetControlPoint method works but if I handle the new spline (scaling, rotating, moving, copy, save) it goes back to the old one.
Regards,
mdiaconu
Another old bug.
SetControlPoint method works but if I handle the new spline (scaling, rotating, moving, copy, save) it goes back to the old one.
Regards,
mdiaconu
SetControlPoint method in Pro 2012 beta
01-11-2011 09:31 . pm | View his/her posts only
hi mdiaconu,
Did you mean you try as following steps:
1. Splinedit>Fit data>Add to add more control point to the spline.
2. run scaling/rotate/move/copy etc to this spline,
result: the new add control point lost
I try as step1 and 2, but can't get the result. Would you tell me your detailed steps to lead to this problem? Jenny2011-11-01 21:31:35
Did you mean you try as following steps:
1. Splinedit>Fit data>Add to add more control point to the spline.
2. run scaling/rotate/move/copy etc to this spline,
result: the new add control point lost
I try as step1 and 2, but can't get the result. Would you tell me your detailed steps to lead to this problem? Jenny2011-11-01 21:31:35
