CAD/CAM discussion forum > 3D CAD/CAM > QM Some suggestions of how to chose and present toolpaths to the potential clien

QM Some suggestions of how to chose and present toolpaths to the potential clien

Rank: 1

Dan

Newbie

posts: 0

Registered: 2002-8-26

Message 1 of 4

 QM Some suggestions of how to chose and present toolpaths to the potential clien
17-03-2004 02:10 . pm | View his/her posts only

If you want to present some QM features you can follow some of the guideliness presented in this post.

Roughing Class

Roughing
Class: Roughing area clearance (lace or offset 2D)
Tool = {D=20, R=0} //End Mill
Surface thick = 1.0 - 3.0mm
Tolerance = 0.1mm
StepZ = 80% * fluteLenght ~=50mm
StepXY = 45% * Tool.Diameter
Intermediary Steps = 5;
Bottom to top = Y
AFC = Y
Wave propagation = Y

Selling Points:

Rank: 1

ChrisWard2k2

Newbie

posts: 2

Registered: 2011-11-22

Message 2 of 4

17-03-2004 06:02 . pm | View his/her posts only
Very consisely explained - should be useful to just about everyone on the planet

Rank: 1

Dan

Newbie

posts: 0

Registered: 2002-8-26

Message 3 of 4

18-03-2004 07:00 . am | View his/her posts only
I hope isn't too technical Chris.

Rank: 1

Robert

Newbie

posts: 0

Registered: 2011-11-22

Message 4 of 4

22-03-2004 12:49 . pm | View his/her posts only
Too bad that Billator didn't save some operations with his post.

Then we could import 'em into a CAM plan and see the results.
See also