CAD/CAM discussion forum > 3D CAD/CAM > cam config editor

cam config editor

Rank: 1

george

Newbie

posts: 0

Registered: 2004-3-1

Message 1 of 4

 cam config editor
11-05-2004 03:25 . pm | View his/her posts only
I do not see where I can change the default setting for cut pattern guide in 9.51.

Rank: 1

ChrisWard2k2

Newbie

posts: 2

Registered: 2011-11-22

Message 2 of 4

12-05-2004 12:14 . pm | View his/her posts only
Hi George

The CAM Op config Editor should be found in the Edit Menu, opdef config.

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 3 of 4

12-05-2004 01:57 . pm | View his/her posts only
Hi Chris,

I was with George yesterday. We know how to get into the editor but the "cut pattern guide" does not seem to be available in the editor. Do you know how to change the default from "part" to "stock"?

Britvic

Rank: 1

george

Newbie

posts: 0

Registered: 2004-3-1

Message 4 of 4

12-05-2004 02:21 . pm | View his/her posts only
I got another e-mail from Matt Fagan and I('ve) seen the demo video that showed which one the cut pattern guide selection was under, it was opdefroff 1012.
See also