Sketcher. Lines connected at endpoints, no constraints displayed
Message 1 of 3
If you draw a line using 'Smartpick' and connect it to the endpoint of an existing line, it constrains it to the end point of that line, but, the constraint symbols are not displayed, therefore cannot be edited, or deleted.
All othe constraints are displayed, just not these.
It is frustrating to say the least.
Message 2 of 3
In case if anyone want to delete the point constraint for the connected lines, for the moment, please use the right click menu and choose Move Entity to skip the point constraint.
Message 3 of 3
Careful with this one....
adding the indication of this constraint will ad a LOT of extra clutter to the screen.
The MOVE tools readily allow the constraint to be broken or just draw another line where you want and delete or trim the dead one.
In 2012 the contraint markers are opague and can obscure a lot of the sketch. Also some dimensions get covered. until, some form of tranparency of these markers is achieved, please do not add any more.
I would suggest that the old wisdom of not having the implied constraint visible is good wisdom. Any change will have other implications that may be worse than the current situation.
A bigger problem is when trimming does NOT add the implied constraint! This means you have to that manually. Fix this first please.
- set autosave in autocad
- any dwf to dwg converter full
- free dwf viewer
- Dwg Converter
- autocad area calculation
- sketchup dwg
- dgn converter
- convert ellipse to polyline
- cad/cam software download
- how to make cross section in autocad
- 2d drawing to 3d model
- how to open dwg on ipad
- 2d drawing
- autocad 2012 product key
- 3d design software free download