Function Error - Isometric Drawings.
Function Error - Isometric Drawings.
06-09-2012 03:51 . am | View his/her posts only
I was doing this isometric drawing for my pipe spools and suddenly says function errorand I wasn't able to use the command again, unless I close ZWCad.
Then, if I am going to close the ZWCad, a pop up will show the runtime error.
I have attached two screenshots I am getting everytime I am doing a isometric drawings.
Then, if I am going to close the ZWCad, a pop up will show the runtime error.
I have attached two screenshots I am getting everytime I am doing a isometric drawings.
Function Error - Isometric Drawings.
06-09-2012 03:58 . am | View his/her posts only
Function Error - Isometric Drawings.
06-09-2012 10:12 . am | View his/her posts only
Hello sir, thanks for the feedback.
ZWMech is developed by ASVIC from Australia, please contact them directly for support request: http://www.asvic.com.au/support.asp
ZWMech is developed by ASVIC from Australia, please contact them directly for support request: http://www.asvic.com.au/support.asp
