ZWSOFT User Community > ZWSOFT Forums - Find. Share. Connect. > ZWCAD > MTEXT issue in the new version??
MTEXT issue in the new version??
MTEXT issue in the new version??
16-09-2012 06:40 . pm | View his/her posts only
The editing of MTEXT has not been corrected in the new release (5622) yet. The cursor and editing are not synchronized i.e the cursor is a few character spaces ahead of where editing is done.
MTEXT issue in the new version??
17-09-2012 11:06 . am | View his/her posts only
It seems that the MTEXT issue you described is not a common happened issue, because i have tried many times, the cursor just goes with the text very well.
is there any special features with the drawing? can you share your system information?
is there any special features with the drawing? can you share your system information?
MTEXT issue in the new version??
17-09-2012 12:26 . pm | View his/her posts only
Reply 2# qinmuting7717
I am using Windows 7 64-bit OS - Intel Core i3 CPU M380 2.53 GHz in 3GB RAM. All the updates for OS installed as released by Microsoft. Also I am using McAfee AntiVirus Security system. Hope this is all and I think these are nothing special. Thanks for your time.
I am using Windows 7 64-bit OS - Intel Core i3 CPU M380 2.53 GHz in 3GB RAM. All the updates for OS installed as released by Microsoft. Also I am using McAfee AntiVirus Security system. Hope this is all and I think these are nothing special. Thanks for your time.
MTEXT issue in the new version??
18-09-2012 07:43 . pm | View his/her posts only
I think I have discovered the problem with MTEXT issue. In case of special characters for example Underline i.e %%U, then the cursor is ahead by 3 characters from the place I want to edit. I hope I am able to make it clear to all.
THX
THX
