Hi, I'm using new zwcad + 2012 with sp1, version 2012.11.29(8448).
Function separate haht is not working. What can I do??

Some other problems:

Sometimes layer isolate and unisolate dosn't work. It's shows some error but there is no message what is wrong.
Plot settings and plot preview is realy slow.

One sugestion:

When I'm using function "area" for mark multiply objects it would be great to show some mask what is marked.

Robert

Hi sir,

Seperate hatch is not yet implemented. It's under developing now and will be available in later updates.

About isolation, is there any way to reproduce the problem by some specific steps?

About plot, is it everytime slow? is it linked to some specific plotter or network problem?

And finally, thanks for you suggestion, we will consider this feature in the future version.

Hi, thanks for quick response.

Here is picture about the problem for isolation. I've got this empty erorr dialog, so when I try to restore layers from this Layiso command I get the same empty erorr dialog. I can't get this to work, so instead I use command Layon, but this is not OK, becouse it restore all my layers.

2013-1-2 15:39

About printing problem.

The problem is only network plotter.

Thanks

Robert

Hi, thanks for the screenshot, but I still can't reproduce this error in my side.

Could you send me the problematic drawing with detailed steps to see this error?
You can send them to : huangyiding@zwcad.com

About printing slow with network plotter, it is a known issue, which can be seen in certain network environment. We will try to improve that in the future. BTW, how slow it is ? and how big is the file?

Hi

I think I've fixed the problem with command isolate. I just purge drawing and now it's working.

About printing, the file sizes are larger then 10 MB. It's slower than in autocad.

Thanks for all your help.

Hi, the separate hatch is implemented in ZWCAD+ 2012 SP2, which will be released in early April. You can stay tuned on our website and this forum~