Supercript Problems ZWCAD12
Supercript Problems ZWCAD12
08-03-2013 01:22 . am | View his/her posts only
I have a problem with the new ZWCAD12 which never happened with the previous version.
On trying to add a superscript (to the power 4 - eg 2^4) in multiline text it works in edit mode. On pressing ok to leave text edit mode, the superscript disappears.
On trying to add a superscript (to the power 4 - eg 2^4) in multiline text it works in edit mode. On pressing ok to leave text edit mode, the superscript disappears.
Supercript Problems ZWCAD12
08-03-2013 09:16 . pm | View his/her posts only
Reply 1# hugh6543
In ZWCAD 2012+ there seems to be another problem with special characters. For example for center-line if you use \U+2104, the symbol shows correctly. But once you save and close, it vanishes on reopening the drawing file.
In ZWCAD 2012+ there seems to be another problem with special characters. For example for center-line if you use \U+2104, the symbol shows correctly. But once you save and close, it vanishes on reopening the drawing file.
Supercript Problems ZWCAD12
08-03-2013 09:28 . pm | View his/her posts only
Reply 2# Tonmoy82
I have had a response fromZWCAD.
I was using 'Corbel' font type.
When I changed to ariel Unicode for the number (to power 4) it worked.
In other words there is an issue with some of the fonts!
I have had a response fromZWCAD.
I was using 'Corbel' font type.
When I changed to ariel Unicode for the number (to power 4) it worked.
In other words there is an issue with some of the fonts!
Supercript Problems ZWCAD12
28-03-2013 04:32 . pm | View his/her posts only
Since ZWCAD+ doesn't support Unicode so well, so it might happen some problem like this. If you use the fonts which itself is Unicode, this problem will not exist(like what hugh6543 has said)
