CAD Question - Revolve Cut/Spiral Sweep issues
Message 1 of 4
Having a slight issue. I am trying to put a diamond pattern into a conveyor roll. I start by drawing the cuts i want to make on the end face of the roll, then i spiral sweep remove the cuts along the face, this works the way i want it to. Picture shows perfect results.
1st Revolve - Perfect
Next, i use exactly the same tool (revolve sweep) exactly the same sketch except this time i check the "revolve clockwise" button to revolve this the other way. The preview looks like this is going to work perfectly. Picture shows the preview looks good.
The problem is, once i click OK i get mixed results. Some of the roll is perfect and some of it is missing the pattern. Picture shows results.
Does anyone know what might be causing this or can anyone offer a way around this?
Thanks in advance for any replies. :P
Message 2 of 4
there is an explanation for the fail it if I am reading your process correctly. The second spiral features cuts though so the original feature is no longer complete - e.g the forming faces have chunk/s cut out it. In truth ZW3 is probably doing a good job. (failed for me)
Try making the spirals as bodies, then pattern, then subtract from cylinder.
You should be able to use the thread tool.
Message 3 of 4
Message 4 of 4
- autocad area calculation
- 2d cam software free download
- any dwf to dwg converter full
- how to open sid file in autocad
- reset autocad configuration
- 3d cad models free download
- zwcad 2014 crack
- autosave autocad
- why can't i explode a block in autocad
- dgn to dwg converter
- autocad 2012 product key
- Elevation drawing in autocad
- autocad license error
- wire rope design
- autocad commands