CAD software discussion forum > ZW3D CAD > Problem Print ing ZW2013 and file dxf

Problem Print ing ZW2013 and file dxf

Rank: 2

Luky

Assistant Engineer

posts: 39

Registered: 2013-1-12

Message 1 of 2

 Problem Print ing ZW2013 and file dxf
27-06-2013 08:55 . pm | View his/her posts only
Buongiorno,avete riscontrato anche voi nella stampa disegni, un rettangolo che sul monitor non ce' ma sul foglio stampato si e se non disattivi la griglia stampa anche quella.
Altra cosa riscontrata,nell'importare un file dxf di grandi dimensioni il file non e' piu' gestibile ossia si blocca la workstation !!
Ho avvisato l'assistenza

Good morning,
you have found yourselves in the printing designs, a rectangle on the monitor do not 'but on the printed sheet and if it does not disable the grid printing, too.
Another thing found, and when a file dxf large the file is not 'more' that is manageable locks the workstation!
I advised the assistance
Bye Luky

Rank: 2

Luky

Assistant Engineer

posts: 39

Registered: 2013-1-12

Message 2 of 2

06-08-2013 05:23 . pm | View his/her posts only
Buon giorno,
ho installato Zw3D Rc1 ed i problemi di stampa e gestione file dxf che avevo riscontrato nella prima relise della 2013, sembrano siano stati risolti con questa versione.
Grazie Luky


Good morning,
I installed ZW3D Rc1 and the problems of management and printing dxf file that I had found in the first Relise of 2013 seem to have been resolved with this release.
thanks Luky
See also