draw sliding door in autocad

Rank: 3Rank: 3

Yusuf

Junior Engineer

posts: 188

Registered: 2012-4-27

Message 1 of 1

 draw sliding door in autocad
04-11-2013 11:10 . am | View his/her posts only
how to draw sliding door in autocad?
autocad contains Dynamic blocks which is an amazing feature, but they can be complicated. And here we will teach you many techniques that you can use in your own blocks. The door will do the following:
1. In a new drawing using architectural units, create a Door layer and make it the current layer.
2. Draw a rectangle 1-1/2″ x 30″. This is the door.
3. Start the ARC command and use the Center option. Specify the lower-left corner of the door as the center. For the first point, move the cursor to the right at 0°, and type 30 on the command line/dynamic input tooltip. Specify the upper-right corner of the door to draw the arc and complete the swing.
4. Select both objects, and start the BLOCK command. Call the block Door. Set its base point at the lower-left corner of the door. Check the Open in Block Editor check box. Click OK. The door opens in the Block Editor with its base point at the 0,0 point of the axes.
5. From the Parameters tab of the Block Authoring palettes, choose Linear Parameter. At the prompt, pick the lower-left corner of the door and then the start point of the arc on the right. If prompted, pick a point below the door for the label.
6. Select the parameter, right-click it, and choose Grip Display> 1. This removes the left grip, which is important because you’ll be stretching from the right grip only. If you don’t do this step, the exclamation point won’t go away when you add the action.
7. With the parameter still selected, open the Properties palette. In the Property Labels section, click the Distance Name item and change the value to Door width.

autocad keygen 2010
autocad 2012 serial number
autocad 2012 crack
See also