CAD/CAM discussion forum > ZW3D CAD > Problemi di fresatura

Problemi di fresatura

Rank: 1

cordon1355

Newbie

posts: 16

Registered: 2013-9-6

Message 1 of 4

 Problemi di fresatura
06-11-2013 05:16 . pm | View his/her posts only
Why in processing "QM- Z-costante 1" machining out of the containment set to "Profile 1" picture looks P173.
Why in processing "QM-SG-spirale 3" processing performs a spiral descent to s along the vertical wall picture looks P173a P173b.

Thanks hello Cordon
P173b.png
2013-11-6 17:11
P173a.png
2013-11-6 17:11
p173.png
2013-11-6 17:11

Rank: 1

Roy

Newbie

posts: 5

Registered: 2011-9-5

Message 2 of 4

07-11-2013 04:48 . pm | View his/her posts only
Hi Cordon,

It is hard to check with your picture.

For a clear idea about your question, would you mind sending your question and this file to

the ZW3D technical support inbox :zw3d@zwsoft.com

Sorry for any inconvenience.

Roy

Rank: 1

Roy

Newbie

posts: 5

Registered: 2011-9-5

Message 3 of 4

07-11-2013 04:53 . pm | View his/her posts only
Hi Cordon,

It is hard to check with your picture.

For a clear idea about your question, would you mind sending your question and this file to

the ZW3D technical support inbox :zw3d@zwsoft.com

Sorry for any inconvenience.

Roy

Rank: 1

cordon1355

Newbie

posts: 16

Registered: 2013-9-6

Message 4 of 4

11-11-2013 06:19 . am | View his/her posts only
Reply 3# Royliu


Sorry but can not log on to technical support ZW3D
See also