CAD/CAM discussion forum > Other CAD/CAM Technology > How to Measure Length in CAD

How to Measure Length in CAD

Rank: 3Rank: 3

Yusuf

Junior Engineer

posts: 188

Registered: 2012-4-27

Message 1 of 1

 How to Measure Length in CAD
13-03-2014 11:43 . am | View his/her posts only
It is very simple to measure the length of the line segment in ZWCAD actually. You just need to double-click the line segment and then you can check the length in the property dialog box at right. Besides, the angle line, the coordinates of the starting point and the endpoint and so on.
The property dialog box is as shown in the figure below.

It is available for ZWCAD mechanical and ZWCAD Architecture as well.
If you want to know more about ZWCAD software or you have other problems, you can join in our technical communication

how to learn cad drawing
CAD learning center
See also