ZW3D Tips: Coil Design
Message 1 of 1
ZW3D Tips: Coil Design
11-06-2014 11:28 . am | View his/her posts only
In product design, coil design is often irregular. How can wecreate many different, interesting coils? Many tips will be introduced through this article, usingactual cases, as shown in Figure 1.
For these three different coils, the most important thing is how to get the 3D curve. Based on the 3D curve, the coil geometry will be quickly calculatedby the ‘Swept Rod’ feature.
Setp1: Create a circle and a line.
Step2: Use the ‘Sweep’ command to create a sweep surface, and then define the linear twist angle from 0 to 7200 degree.This can be seen in Figure 2.
Step3: Select the edge of the sweep surface to do the swept rod operation. Finally, get the coil shape.
Step1: Draw two lines and a spiral curve; see Figure 3(left).
Step2: Create a sweep surface with these curves; see Figure 3(right).
Step3: Create a revolve surface with a sketch curve.
Setp4: Create a curve at the intersection of two or more faces,and then uses theSweep Rod command to create a rod shape.
Step1: Create a cylinder base shape.
Step2: Create a sweep surface with twist angles (such as: from -5400 to 5400 degree), similar to that in case 1.
Step3: Use this shape and surface to generate an intersection curve.
Step4: According to the actual requirements, draw the lead-in and lead-out side curves.
The whole process of creating 3D curves isshown in Figure 5.
Step5: Do sweep rod operation to generate the coil shape.
Some tips can be summarized from these several different case. For coil design, the key point is creating a correct 3D curve. Many different methods are available. Equation curves can be directly used for some simple shapes whereas some irregular coil shape would use the sweep feature and some other commands to create reference solids or surfaces,and then get the requiredcurves based on these reference geometries.Using different commands for different requirements can make design work easier andmore interesting.
For coil design, the key point is creating a correct 3D curve. Many different methods are available. Equation curves can be directly used for some simple shapes whereas some irregular coil shape would use the sweep feature and some other commands to create reference solids or surfaces,and then get the required curves based on these reference geometries.
For more detail of this articl, please click here.
For more technical tips, please click here.
- 2d convert to 3d free drawing software download
- 3d design software free download
- freecad download
- how to make cross section in autocad
- download cad cam
- autocad 2012 product key
- skp to dwg
- cad for students
- How to open an autocad file
- how to find area in autocad
- unlock viewport
- 3D CAD/CAM Design Software
- autocad show the file path
- what is the difference between dwg format and dxf format
- mechanical design software free download