Assy Alignment Help
Message 1 of 4
I am tryng to get the rod not to be flush with the bottom of the block, I want it recessed 5mm (offset z positive). I got it concentric but I have seen no way to axially align the rod. There is offset under alignment edit, but that is not what I need, that offsets in a y direction. What is the right way to put it as I described? Also, the hole thru the rod is aligned along the x axis, I want it 45
Message 2 of 4
Message 3 of 4
I have attached a corrected file or your part.
here are the steps I took.
On inserting the first part chose to anchor it. You can do this after by RMB on the part and choose anchor too.
Insert the pin. Align concentric first. I find choosing alignments in an order that allows me to select the next alignment feature helps. e.g. not obsucred by a half baked alignment.
Then align the pin faced coincident and apply the 5mm offset. Try changing alignment to Opposite if it goes the wrong way.
TIP: When doing an alignment RMB will allow a Critical or On entity selection. On entity is often easier to see and for selecting faces.
Angle. I selected the a vertical and the bore of the pin hole then the angle symbol and dial up 45deg.
TIP: You can turn on External Datums via the View Menu which will allow you to see the planes on the incoming parts. These can also be aligned. Itcan also getquite cluttered.
TIP: You can use the filter to help select the right type of feature for your alignment - face, edge etc.
Hope it helps.
Message 4 of 4
- combine two regions in autocad
- how to open microstation drawing in autocad
- cad cam software
- autocad cursor highlights polylines
- dwg 3d
- how to open dwg on ipad
- mechanical engineering autocad software free download
- 2d drawing
- How to Extend Objects in AUTOCAD
- mechanical softwares free download
- acad dwg viewer
- Free 3d house design software
- autocad autocomplete command
- how to print multipage dwg
- cad free download