conversion ap
conversion ap
18-05-2008 07:52 . pm | View his/her posts only
There is a little program called "convert" that I use when working with MM and INCHES in the same part and I can also convert lots of other things to if I wish but I find it handy to have and hope you will to. Google "joshmadison.com/software" for it.
conversion ap
18-05-2008 08:45 . pm | View his/her posts only
Hi Cutter
Looks good. You might like to try the DAS Unit Converter too: DAS
In VX you can switch on Alternate Units (via Attributes/Dimensions) to display both metric and inch values.
conversion ap
11-06-2008 10:05 . am | View his/her posts only
Here is a little diddy about units for any new users tuning in.
If you are in a part with mm units and you are given a dimension of 6 inches, instead of converting with a calculator or looking up the conversion in a table you can input the number directly as 6.in
By the same token in an inch part you can enter 12.mm and we do the conversion internally.
If you are in a part with mm units and you are given a dimension of 6 inches, instead of converting with a calculator or looking up the conversion in a table you can input the number directly as 6.in
By the same token in an inch part you can enter 12.mm and we do the conversion internally.
