Hi Mike,
can you tell us when V14 is being released.
I am desperate for a decent sketcher as I am sick of the flipping/self inverting arcless caddywonkus I have had to struggle with till now.
Cheers

Who, what, where, when?... all good questions; and I have answers. (Why? is the only one I don't touch)
(All in good time...)
In fact, the weeks have been short; I was out for two days last week, then we had a Holiday back in February.
Look, I am as anxious as you are to see V14 released but I am just the messenger. You folks on the forum will be the first to know.
I did update the training manuals and the Release Notes link on the VX support site now defaults to V14 so take this opportunity to glace through them.
A new license will be necessary so if you have a dongle take a few minutes to prepare. You will need to delete the oldest of the two licenses on the dongle. The hardware keys only hold two licenses so you need to make room for the new one.

OK, Gentlemen start your engines!! V14 is now on the VX Support site. I am currently downloading it but I didn't want one of you getting it before I did...
Just a reminder, you must have a current maintenance contract to get a license.

Thanks Mike,
have looked at a couple of the revised training manuals - nice job - looking much better.

Also think the gallery is a much needed addition to the website - of course the challenge is for users to relinquish suitable objects for display ... hmmmm.

So congrats to VX for releasing 2009 nearly on target - we all know the massive effort making targets takes.

Thanks again.

Now the acid tests...................................

You guys will want to use this link to download instead of going to the VX support site because the bandwidth is 2 1/2 to 3xs better.
http://mirror1.vx.com.s3.amazonaws.com/vx1400-full.zip