ZWSOFT User Community > ZWSOFT Forums - Find. Share. Connect. > ZW3D CAD/CAM > Clock Core and cavity
Clock Core and cavity
Clock Core and cavity
10-02-2010 09:02 . am | View his/her posts only
Clock core and cavity with VX mold & Die function, but partline plane has a little problem.
Clock Core and cavity
10-02-2010 10:59 . am | View his/her posts only
Your attachment doesn't work.
Clock Core and cavity
10-02-2010 11:12 . am | View his/her posts only
I understand your meaning, I compressed a file of .zip format
Clock Core and cavity
10-02-2010 11:21 . am | View his/her posts only
I have no problems opening 7zip files, clicking on your attachment sends me to a "page not found" error.
Clock Core and cavity
10-02-2010 11:38 . am | View his/her posts only
I can't see the problem (I can open the VX file) , can you upload a .png screenshot that shows what the problem is?
Clock Core and cavity
10-02-2010 12:08 . pm | View his/her posts only
Yes, it is no problem now, but when design partling plane has problem, you can replay history record find it.
Clock Core and cavity
10-02-2010 01:28 . pm | View his/her posts only
Steve,
Take a look at the attached image. The highlighted surface was created from the "red" parting line and was coincident with the dark blue face. Therefore, it could not sew properly. Because this face does not have any draft the parting line was created incorrectly. You can trim the face then sew, like I did or go back and replace the parting line then create the parting surfaces again.
The draft analysis tools should find this.
Take a look at the attached image. The highlighted surface was created from the "red" parting line and was coincident with the dark blue face. Therefore, it could not sew properly. Because this face does not have any draft the parting line was created incorrectly. You can trim the face then sew, like I did or go back and replace the parting line then create the parting surfaces again.
The draft analysis tools should find this.
