CAD software discussion forum > 3D CAD/CAM > New Category for discussion of ZW3D CAM

New Category for discussion of ZW3D CAM

Rank: 1

Chris

Newbie

posts: 0

Registered: 2002-8-22

Message 1 of 3

 New Category for discussion of ZW3D CAM
24-09-2010 08:18 . am | View his/her posts only
This category was created to allow discussion of the ZW3D CAM functionality.

Rank: 1

cutter

Newbie

posts: 55

Registered: 2011-11-23

Message 2 of 3

24-09-2010 07:05 . pm | View his/her posts only
Hey Mike,
Which aspect of what we have not seen do you wish to discuss? :-}

Rank: 7Rank: 7Rank: 7

Paul

Moderator

posts: 311

Registered: 2011-9-17

Message 3 of 3

25-09-2010 03:50 . am | View his/her posts only
Might I suggest that etherial Phantomware is a somewhat elusive subject until it materialises, sometime on a PC near you ...
See also