CAD/CAM discussion forum > CAD > use zwcad to plot or publish dwg file to DWF, DWF file not showing

use zwcad to plot or publish dwg file to DWF, DWF file not showing

    
  Subscribe Topic

Rank: 1

Craig Kennedy

Newbie

posts: 0

Registered: 2009-5-21

Message 1 of 5

 use zwcad to plot or publish dwg file to DWF, DWF file not showing
09-06-2009 02:50 . pm   |   View his/her posts only
When i plot or publish a dwg file to DWF, it shows that the file has been DWF'd, but when i search for the file on my desktop or in the selected folder, it is not there. this is strange because my method is correct as to exporting to DWF, all settings are correct, but the file just is not where it should be. Any suggestions on this matter, urgent help is needed.

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 2 of 5

18-06-2009 11:26 . am   |   View his/her posts only
Could you please tell me the version of ZWCAD you are using?
You could get the version number by the command VERNUM.

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 3 of 5

18-06-2009 11:27 . am   |   View his/her posts only
I would like to verify that with the corresponding version of ZWCAD.

Rank: 1

Lars

Newbie

posts: 0

Registered: 2010-12-14

Message 4 of 5

18-06-2009 09:31 . pm   |   View his/her posts only
Hi Sirius,

Version 2009.05.12(10270) works fine.
Vernum 2009.03.31(9752) = File is empty

Regards,
Lars

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 5 of 5

19-06-2009 02:27 . pm   |   View his/her posts only


Thanks for the valuable information.


We would make a comparison and try to find out the reason. And I suppose you upgrade your ZWCAD to the latest one at present.Wink
See also
X