Message 1 of 6
I built a small assembly in a single part, and then extracted every shape as a single part, without trouble, until I made changes.
This process is clearly documented in ZW3D help, which states:
"7 This command should be the very last in your part history. All design edits before this command should be done by “stepping through” or "redefining" the history. A regen will re-extract the edited geometry and overwrite previous names."
which makes sense.
Unfortunately, it doesn't seem to work like that. If I made changes in a shape in the history, it seems there is no regen.
Worse than that, if I manually replay history and edit the "Extract shape" command, the tool panel displays the "Insert a component" pane.
Did I miss something or is it a bug?
ZW3D 32 bits V17.05.
Message 2 of 6
Nevertheless, the extract shape behaviors seems somewhat strange.
Message 3 of 6
Message 4 of 6
William is here ^ _ ^.
Sorry for the any inconvenience cause by the not updated help document in 1705, in fact, the "extract shape" works different between "Assembly mode"
(Regarding the Asssembly mode, you can change it on configuration.)
More detail about Assembly mode, you can refer to Help document.
So the correct explaination about "Extract shape" was corrected in 2013 SP (1710) help document.
Message 5 of 6
Message 6 of 6
- set autosave in autocad
- why can't i explode a block in autocad
- How to open an autocad file
- acad dwg viewer
- 2d drawing to 3d model
- buy solidworks 2009
- free cad software
- autosave autocad
- mechanical drawing software
- drawing angles in autocad
- how to open dwg on mobile phone
- zwcad 2011 crack
- How to Extend Objects in AUTOCAD
- autocad area calculation
- buy cad software