Message 1 of 2
If then say you had a rotate copy the input in this for number of copies is numerical. however you cant copy somethin 1.125 time only 1,2,3 4 etc.
Whatever the step size was set to, this did not affect the copy command but only fillet etc.
In 11.21, unless step size is set to one, the up down arrows to increase number of copies will not change the value.
Message 2 of 2
- autocad menu bar
- where do the roll or fold lines go on sheet metal drawings
- 3d cad design
- zwcad 2010 download
- How to install ZWCAD
- how to find area of irregular shapes in autocad
- How to convert Mtext to Text
- how to make cross section in autocad
- dgn autocad
- free 3d cad software download
- how to use mateirals in autocad 2013
- cad cam software free
- free 3d cam software
- autocad block does not explode