CAD/CAM discussion forum > CAD > There was a problem sending the command to the program

There was a problem sending the command to the program

    
  Subscribe Topic

Rank: 1

kashir9834

Newbie

posts: 1

Registered: 2016-6-27

Message 1 of 4

 There was a problem sending the command to the program
27-06-2016 05:54 . pm   |   View his/her posts only
Hi

We have WZcad 2011 Version 2010.11.25(16241)& we are geeting following error while opening Wzcad file.

There was a problem sending the command to the program.


Regards,
kashiram sawant

Rank: 5Rank: 5

Support_ZWCAD

posts: 572

Registered: 2015-6-9

Message 2 of 4

01-08-2016 04:41 . pm   |   View his/her posts only
Reply 1# kashir9834


Thanks for your feedback. We have received some problem like this before, but here we reproduce just occasionally. And usually, you can close it and the file will still
be opened normally. Does this issue happen a lot in your situation?

Rank: 1

lohyenwei3874

Newbie

posts: 1

Registered: 2017-4-20

Message 3 of 4

20-04-2017 09:52 . am   |   View his/her posts only
Hi Sir, I have encountered that problem on a particular machine which could not open the files in specific folder with that error prompted. Is there a prerequisite to open the file? I have also tried to open / recover the file from the program however it will tend to HANG and not responding. I have also go into options to reset the default profile settings. Please advice.

Rank: 5Rank: 5

Support_ZWCAD

posts: 572

Registered: 2015-6-9

Message 4 of 4

22-04-2017 04:01 . pm   |   View his/her posts only
Reply 3# lohyenwei3874


Hi, Which version are you using? Is it 2017? Does this problem happen when you open the files by double clicks files? If so, I think you can try to open the software first and then command OPEN to open files.
See also
X