Unfolding the Part

    
  Subscribe Topic

Rank: 1

OldForumPost

Newbie

posts: 0

Registered: 2012-1-14

Message 1 of 3

 Unfolding the Part
01-02-2006 01:46 . pm   |   View his/her posts only
I have unfolded a part and no matter what I change the k factor to it doesn't effect the outcome.

Also, once the part is unfolded the overall dimension does not equal that of the one in CADKEY(which was done using the rule of 1/3 metal to unfold it)

It also doesn't unfold one bend to 0

Rank: 1

Robert

Newbie

posts: 0

Registered: 2011-11-22

Message 2 of 3

04-02-2006 04:19 . pm   |   View his/her posts only
Hi Jeffrey,

Have you sent the part to Mike Lynch at VX support? mikel@vx.com

If not, please do so that we can see what's going on.

thanks,

Rank: 1

Kyonghun

Newbie

posts: 0

Registered: 2002-8-28

Message 3 of 3

07-02-2006 06:36 . pm   |   View his/her posts only
Hmm, the only tool that may do that is the "change bend angle" command, but in this case, it wouldn't be the correct command. The K-factor issue maybe related to this, but need to see the part to be sure. Please do send it to our support.

See also
X