CAD/CAM discussion forum > CAD > Cutting probem.

Cutting probem.

    
  Subscribe Topic

Rank: 1

domnov1395

Newbie

posts: 1

Registered: 2017-3-8

Message 1 of 5

 Cutting probem.
08-03-2017 03:48 . pm   |   View his/her posts only
Hello to all,i find a problem in cutting command in ZWCAD 2017.

Drow a circle, drow a orizzontal center line from each quadrant point now try to cut te circle.


help me please.

Rank: 4

Goran

Senior Engineer

posts: 89

Registered: 2011-7-16

Message 2 of 5

10-03-2017 01:56 . am   |   View his/her posts only
Maybe trim is command you need?

Rank: 5Rank: 5

Jeffrey_ZWCAD

posts: 456

Registered: 2015-6-9

Message 3 of 5

13-03-2017 01:48 . pm   |   View his/her posts only
Reply 1# domnov1395


Hi, thanks for your feedback. We reproduced this issue and will fix it in next version, which will be released at the end of this month.
Before that, you can use BREAK command to cut the circle by the line. Thanks.

Rank: 4

Goran

Senior Engineer

posts: 89

Registered: 2011-7-16

Message 4 of 5

Rank: 5Rank: 5

Jeffrey_ZWCAD

posts: 456

Registered: 2015-6-9

Message 5 of 5

16-03-2017 03:19 . pm   |   View his/her posts only
Reply 4# goranP

Hi Goran, Thanks you for your feedback. For the following issues:

(1)http://www.zwsoft.com/zwcad_forum/thread-4803-1-1.html

(2)http://www.zwsoft.com/zwcad_forum/thread-4740-1-1.html

(3)http://www.zwsoft.com/zwcad_forum/thread-4606-1-1.html

(4)http://www.zwsoft.com/zwcad_forum/thread-4525-1-1.html

(5)http://www.zwsoft.com/zwcad_forum/thread-4774-1-1.html

(6)http://www.zwsoft.com/zwcad_forum/thread-4780-1-1.html



The (1) we still need to confirm with you, and please check the reply in that page, or you can send an email to hejunhui@zwcad.com directly.
The (2), the bug ID is 6831, and it will be solved in SP3 according to the plan.
The (3), the bug ID is 7026, it is planned to be solved in ZWCAD 2018.
The (4) is Design Center and (5) (6) are about Tool Palette improvements, both of them are important functions, and we will make some improvements in ZWCAD 2018.


Thanks.
See also
X