CAD/CAM discussion forum > CAD > Flexible subassemblies

Flexible subassemblies

    
  Subscribe Topic

Rank: 1

jimbees7518

Newbie

posts: 1

Registered: 2017-4-19

Message 1 of 2

 Flexible subassemblies
19-04-2017 10:36 . am   |   View his/her posts only
I am a newbie to ZW3D using the evaluation licence ZW3D to model a gateleg table. I have made an top assembly which incorporates a hinge subassembly in a gate subassembly in the main assembly. There are two layers of subassembly below the main assembly. The hinges are aligned to faces by the axis of the hinge pin within the gate subassembly. How do I make the hinges flexible so that I can move the gate leg within the top table assembly. I usually use Geomagic Design which has subassembly flexibility to 2 layers of subassembly.

Rank: 5Rank: 5

Support_ZWCAD

posts: 572

Registered: 2015-6-9

Message 2 of 2

22-04-2017 04:10 . pm   |   View his/her posts only
Reply 1# jimbees7518


Hi, you can post the ZW3D issue in the following forum, thanks.http://www.zwsoft.com/zw3d_forum/
See also
X