CAD/CAM discussion forum > CAD > Can't find intersection of the lines

Can't find intersection of the lines

    
  Subscribe Topic

Rank: 2

bartek8964

Assistant Engineer

posts: 26

Registered: 2017-1-16

Message 1 of 4

 Can't find intersection of the lines
08-06-2017 02:39 . pm   |   View his/her posts only
I draw two lines not intersecting and I want to find the intersection point on extension of the second line. And sometimes I can't find this point. It depends on which direction we draw the second line (if in the direction of the drawn line, it is ok, if the opposite, then there is no point of intersection).

Rank: 5Rank: 5

Support_ZWCAD

posts: 572

Registered: 2015-6-9

Message 2 of 4

11-06-2017 06:12 . pm   |   View his/her posts only
Reply 1# bartek8964


Hi, we tried to reproduce the issue, as can you see from the attached video, but didn't reproduce. Maybe some steps missed. Could you tell us how to reproduce it. Thanks. 2017-06-11_18-08-48.rar (1.17 MB)

Rank: 2

bartek8964

Assistant Engineer

posts: 26

Registered: 2017-1-16

Message 3 of 4

14-06-2017 03:51 . pm   |   View his/her posts only
Hi Jeffrey. I send You a mail with attached videos. As You can see, intersection point (if it appears) has less priority than other points. It's a very big problem, because I can not draw precisely

Rank: 5Rank: 5

Support_ZWCAD

posts: 572

Registered: 2015-6-9

Message 4 of 4

19-06-2017 03:47 . pm   |   View his/her posts only
Reply 3# bartek8964


Hi Bartek, Thank you. I received your mail, and already replied to you. Please check.
See also
X