Subscribe Topic

Rank: 1

george

Newbie

posts: 0

Registered: 2004-3-1

Message 1 of 4

 STL VERIFY
03-01-2007 10:29 . am   |   View his/her posts only
Has anyone seen an issue with 12.66 not reading an stl stock for verification? When I try it I get a simple box instead of my desired stl model. I know this worked in the past.

Rank: 1

ChrisWard2k2

Newbie

posts: 2

Registered: 2011-11-22

Message 2 of 4

03-01-2007 02:42 . pm   |   View his/her posts only
Hi George

It is probably STL file specific - have you tried an existing VX file that successfully used an STL for Solid Verify in a previous VX version?

Rank: 1

george

Newbie

posts: 0

Registered: 2004-3-1

Message 3 of 4

04-01-2007 04:59 . am   |   View his/her posts only
I have not but the stl is from a VX part that was made in VX. I would think that would be good wouldn't it?

Rank: 1

ChrisWard2k2

Newbie

posts: 2

Registered: 2011-11-22

Message 4 of 4

04-01-2007 08:10 . am   |   View his/her posts only
Certainly the STL file output from VX Solid Verification would normally be a good file. The world isn't perfect though, there are always going to be exceptions.
See also
X