Message 1 of 6
Message 2 of 6
Message 3 of 6
How do you add more connection points to avoid twisting etc in the first place? I can modify the one that is automatically created (Advanced tab) but can't add any more.
Message 4 of 6
questions are very good.
Two AVI's courtesy of CJW some time back. Chris can give a fuller explanation than I, but the videos give an insight into deleting old connection lines, adding new, using RMB during point selection, auto lines etc. VX can do it!
The coolest tip about lofts.(ex CJW)
If you can loft between two shapes, rather than making the loft an end feature, removing the end caps (surface to surface loft) enables automatic surface tangency at each end. Does a lovely job. I sometimes make a profile, extruded it minus end caps, then done the loft then erased the extrude. (This rather than straight to a sketch profile) Tangency remains, so I now have the nice transition for the next feature and no fiddling with end tangency etc. Very nice.
Message 5 of 6
Which is something I continue to struggle with! Be nice if in v13 VX could simplify this selection process in some way.
Mike I'll send you those bathtubs to see how VX handles those (closed) lofts. Problem I've got is I can do this stuff (fairly) easily in other apps I use but whenever I try in VX I get lost....and yes it is my fault but deadlines dictate getting stuff out the door so I never have time to get to grips with VX properly (give me a week and I could....ha! a week!!). Be prepared for lots of questions next week :-)
Chris are you going to the VX user day next week? If so see you there :-)
Message 6 of 6
- how to convert a bak file to dwg
- ac$ to dwg
- zwcad 2013 download
- autocad block does not explode
- autocad to sketchup
- fadal emulator
- autocad 2012 serial number
- dgn to dwg
- autocad area calculation
- How to print a multi-page PDF from drawings
- drawing a gear in autocad
- how to use mateirals in autocad 2013
- Download free 3d models
- zwcad 2009 professional
- How to draw a house plan in autocad?