ZW3D CAM Tips ( Operations —— How to choose among drill, bore and ream operations)

\Drilling is always the first to choose from as long as it meets your tolerance requirements. If higher tolerance is required, consider reaming next for smaller holes (less than 1 inch in diameter). Reaming is considered over boring because it is easier and more economic to perform. Boring should be considered for relative large holes only. 


Review date: 2011-May-24
Applies to:

PrintPrint Get a PDF version of this webpage PDF
© 2013 ZWCAD Software Co., Ltd. All rights reserved. | Sobre a ZWSOFT | Política de Privacidade | Termos e Condições | Contate-nos | Mapa do Site
All trademarks, trade names or company names referenced herein are used for identification only and are the property of their respective owners.