ZW3D CAM Tips ( Speeds & Feeds —— How to output spindle speed in decimal format)

\You can choose to output spindle speed in decimal format.  Perform the following steps to do so.

  1. IMPORTANT: First make a backup copy of the post processor configuration file "fanuc10.fp" located in the "output_def" folder of your ZW3D installation folder (e.g., fanuc10_bak.fp). 
  2. Next, edit the "fanuc10.fp" file to change the SPINDLE_SPEED_DECIMAL flag to "TRUE."  By default this flag is set to "FALSE."  This flag is located under the "General Settings" section of the file.  See below.

    # General settings.


Review date: 2011-May-24
Applies to:

PrintPrint Get a PDF version of this webpage PDF
© 2017 ZWCAD Software Co., Ltd. All rights reserved. | Über ZWSOFT | Datenschutzrichtlinie | Begriffe und Bedingungen | Kontaktieren Sie uns | Site Map
All trademarks, trade names or company names referenced herein are used for identification only and are the property of their respective owners.