What is the basic procedure for creating a mold?


  1. Split part into core and cavity
  2. Turn auto-sew off
  3. Parting lines on the core
  4. Parting surfaces
  5. Create an extrusion for the mold plate
  6. Subtract core from the plate
  7. Blank part/plate
  8. Sew
  9. Possibly have to Reverse Normals. (Red side of the parting Surface is what gets trimmed away)Unblank
  10. Subtract parting surface from the plate


Review date: 2011-May-18

PrintPrint Get a PDF version of this webpage PDF

© 2017 ZWCAD Software Co., Ltd. All rights reserved. | A proposito di ZWSOFT | Privacy Policy | Terms and Conditions | Contattaci | Site Map
All trademarks, trade names or company names referenced herein are used for identification only and are the property of their respective owners.